|
TIMBER
All timber are Pine wood and are treated with Chromated
Copper Arsenates. All plywood components are treated
marine grade water proof plywood. All sections are fully
machined prior to treatment.
STRUCTURAL FRAMING
Structure is bolted and is designed to withstand all
operational loads and wind pressure.
HARDWARE
Hardware such as nuts, bolts, washers, ring connectors
etc. shall be Hot dip galvanized steel.
INTERNAL FILL & FILL SUPPORT
Rectangular Fill splash bars are designed to offer
maximum splash and wetted surface in such a manner that
it permits no dislocation of splash bars and yet allows
them to expand or contract with changes in moisture
content of wood without cracking, warping or sagging.
Splash bars are supported in GRP grid supporters, which
are firmly attached to structural girt members.
DRIFT ELIMINATORS
These are
made of treated timber planks supported on grooved
treated plywood Eliminator frame in herringbone pattern.
CASING & AIR INLET LOUVERS
These will be made of corrugated AC Sheet. Tower corners
are covered by FRP boards. Casing is water tight
sealed. Air inlet Louvers are of corrugated AC Sheets.
DISTRIBUTION SYSTEM
Cross flow
towers employ a flooded pan distribution. The open pan
covering the entire fill area distributes hot water
evenly over the fills by means of PVC nozzles.
FAN DECK
The fan deck is of FRP Construction .
FANS :
Dynamically balanced Cast
Aluminium Alloy / FRP Fan
MOTOR :
TE-IP 55 With EN -8/9
Shaft. |
